Switchport trunk encapsulation dot1q (ESXi/ESX only supports dot1q, not ISL) This sample is a supported Cisco Trunk Port configuration: Therefore, if the ESXi/ESX host is set to VST mode, it drops the packets that are lacking a VLAN tag. Native VLAN packets are not tagged with the VLAN ID on the outgoing traffic toward the ESXi/ESX host. Do not assign a VLAN to a port group that is same as the native VLAN ID of the physical switch. VLAN Routing – and VLAN IsolationCaution: Native VLAN ID on ESXi/ESX VST Mode is not supported. Spanning-tree is set to portfast trunk (for example, port forwarding, skips other modes) ESXi/ESX only supports IEEE 802.1Q (dot1q) trunking.
Set the physical port connection between the ESXi/ESX host and the physical switch to TRUNK mode. To configure the physical switch settings:ġ.ĝefine ESXi/ESX VLANs on the physical switch.Ģ.Ěllow the proper range to the ESXi/ESX host.ģ. Set the switch NIC teaming policy to Route based on originating virtual port ID (this is set by default). VLAN ID 4095 Enables trunking on port group (VGT Mode)Ģ.
VLAN ID 0 (zero) Disables VLAN tagging on port group (EST Mode) To configure Virtual Switch (vSwitch) VLAN Tagging (VST) on an ESXi/ESX host:ġ.Ěssign a VLAN to a portgroup(s). This article provides a sample network configuration for isolation and segmentation of virtual machine network traffic. Sample configuration of virtual switch VLAN tagging (VST Mode) (1004074) Set the Network Adapter of the VM to use the VM Network for VLAN635ĭ.Ěssign IP on VM and test the connectivity, you can ping the Gateway now (VLAN IP Address) vmic1 this NIC should be connected on the switch configured as Trunk above.)Ĭ. #switchport trunk allowed vlan Ĭreate a vSphere Standard switch (Choose the Physical NIC e.g. Note: On layer 3 Switch, there should be a routing configurations so that the switch knows where to route the traffic. 1.Ĝonfigure the switch (L2/元) Cisco Switchī.Ěssign IP Address for the created VLAN (This will be the gateway of VMs)
0 kommentar(er)
